Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port Forwarding issue 871 ethernet router

I cannot connect to my dvr from outside my network. The port is open and working inside my LAN. I used the following commands to no avail. Any ideas? I've tried just about everything

ip nat inside source static tcp 192.168.1.10 7000 interface FastEthernet4 7000

access-list 100 permit tcp any any established

access-list 100 permit tcp any any eq 7000

4 REPLIES

Re: Port Forwarding issue 871 ethernet router

Try the following:

ip nat inside source static tcp 192.168.1.10 7000 1.1.1.1 7000 route-map nonat extendable

access-list 140 deny ip host 192.168.10.1 any

access-list 140 deny ip any host 192.168.10.1

access-list 140 permit ip any any

route-map nonat permit 40

match ip address 140

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: Port Forwarding issue 871 ethernet router

Thanks for the reply.

That did not solve the issue.

I can get to the DVR username/password prompt but when I put in the password, the prompt just comes right back until I try it three times and it logs out. Is there a way I can tell if I am actually connecting to the dvr from the outside.

New Member

Re: Port Forwarding issue 871 ethernet router

Anyone???

New Member

Re: Port Forwarding issue 871 ethernet router

Well, if you are getting a username/pass prompt it sounds like you are making a connection. If you wanted to verify, during a connection, login to the router and issue "show ip nat trans" to see your active NAT translations and check to see if there is a translation.

926
Views
0
Helpful
4
Replies