Alright, I just don't understand Cisco port forwarding. I have a 2610 with a NM-1E and I want to setup port forwarding. I have the router configured and it works great, but now I need some ports configured.
The way things worked on my old router, I had a DMZ setup forwarding all to one IP, but I also had some individual port ranges setup as well. SO:
DMZ to 192.168.1.3
9300-9399 to 192.168.1.3
9400-9499 to 192.168.1.4
9500-9599 to 192.168.1.5
etc, etc.
Is there any way to do this on the Cisco router?
Also, on my Linksys, if I attempt to connect to the external IP from behind the network, it would simply pass the connection through port forwarding as if it had been external. I used the following command to configure what I think was a DMZ, but I can't connect to the "external" ip from within the network...
ip nat inside source static 192.168.1.3 65.41.113.xx