Recently we have run into problems with port security when a PC is replaced. I have cleared the mac address table in the interface, cleared the sticky address, shut, no shut, removed, and readded port security. The PC will grab an IP address when port security is removed, but as soon as it's reapplied it drops connectivity again. Is anyone else running into this problem??
Re: Port Security Blocking New MAC on PC Replacement
Have you checked the mac address learned on the port in the running config of the interface..?? is it the same as of PC ? sometimes due to mac spoofing by viruses multiple macs are learned on the switch's interface and as port security by default enables single mac on an interface it gets violated upon learning 2 mac addresses.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...