I'm using the following Port Security config in my switch ports:
switchport mode access
switchport port-security maximum 2
switchport port-security violation restrict
switchport port-security mac-address sticky
The problem is that the switch learns the first and second MAC Address connected and if i disconnect one PC and plug another one, it does not work. What should i do to automatically switch these MACs addresses?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...