Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port security configuration

Hello Friends,

I have a very different requirement to be configured on the 24 port catalyst  switch. Switch details are given below

C2960-LANBASEK9-M, Version 12.2(53)SE1, RELEASE SOFTWARE (fc2).

IP address assigned to users should not be used by others, and the assigned  IP address should be binded to MAC address of the client laptop on one of the  switch port. If any user tries to use other than the assigned IP address should  be blocked.The user should communicate only through his approved MAC address and  given IP. Changing any one of them should be blocked. Maxumum users connected to  this port is approximately 350.

Is it possible to configure the above requirement through the switch IOS, if  yes pl tell me how to do it or post the URL.

Pl guide me how to achieve this.

Regards,

Raghavan.

1 REPLY
Bronze

Re: Port security configuration

Hi Raghavan.

Will your laptops be using DHCP? If so, what you're asking is possible (not positive about the 2960 platform though). Take a look at these items:

  • DHCP Snooping
  • Dynamic Arp Inspection
  • IP Source verification

The 2nd two items depend on DHCP Snooping. It sounds like these will do exactly what you need them to.

330
Views
0
Helpful
1
Replies