Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port Security question

I'm currently allowing only one mac address on my port, my config look like this

set port security 1/7 enable age 10 maximum 1 shutdown

I expect that if I unplug a pc from port 1/7 and plug this same pc back in port 1/7 before the 10 min againg timer expires, system should not disable my port. But it doesn't happen that way, port 1/7 goes into shut down mode as soon as i plug in the same pc. Any thoughts?

1 REPLY
New Member

Re: Port Security question

once you plugged in the pc back again, check the numbers of mac-address on port 1/7, how many? the switch might still store the mac-address up to 10 minutes after you unplugged, then once plugged in back, the switch thinks that there are 2 mac-address on that port.

show logging

to check the violation logs.

97
Views
0
Helpful
1
Replies