Switch(config-if)# switchport port-security maximum 10 vlan access
Switch(config-if)# switchport port-security maximum 10 vlan voice
I know my English is deficient, but I don't understand what the keyword "sticky" is present on only some MAC addresses are configured on the interface but not for all of them.... French traduction of the word "sticky" was'nt help me a lot !!
I had understand if the command :"switchport port-security mac-address sticky" is used on the interface the port is allowed to dynamitly learn MAC addresses and add then to his running-config file... if the configuration is saved thoses MAC addresses are alway's configure on that interface and allowed to use this interface, before any other MAC address can be learn in the interface, if maximum is reach because of thoses command no other MAC addresses can be added.
But, what is the difference between thoses 2 commands if they are in running-config and startup-config (except for the MAC address it self) ??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...