Question: How no switchport command for the interface will solve the issue?? Please advise
Below are the details of the BUG
Port goes into err-disabled state because of port-security security violations. This happens due to "Total MAC address" learned is not synced across the stack members.
Conditions: configure "switchport port-security maximum " on an interface on a stack member and send traffic from the device connected to it. After sometime, device goes into err-disabled state because of the security-violations.
Workaround: Run "no switchport" command for the interface.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.