Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port Security

 

I have enabled port security and tested it...

 

sw1#show port-security
Secure Port  MaxSecureAddr  CurrentAddr  SecurityViolation  Security Action
                (Count)       (Count)          (Count)
---------------------------------------------------------------------------
      Fa0/9              1            1                  1         Shutdown
---------------------------------------------------------------------------
Total Addresses in System (excluding one mac per port)     : 0
Max Addresses limit in System (excluding one mac per port) : 1024

How can I get out of this ? How to make the port back to active state ?

 

sw1#show port-security interface fastEthernet 0/9
Port Security              : Enabled
Port Status                : Secure-shutdown
Violation Mode             : Shutdown
Aging Time                 : 0 mins
Aging Type                 : Absolute
SecureStatic Address Aging : Disabled
Maximum MAC Addresses      : 1
Total MAC Addresses        : 1
Configured MAC Addresses   : 0
Sticky MAC Addresses       : 1
Last Source Address        : 3c97.0e84.aa7d
Security Violation Count   : 1

1 ACCEPTED SOLUTION

Accepted Solutions

Hey Jack,Adding a link for

Hey Jack,

Adding a link for port-security for references:

http://packetlife.net/blog/2010/may/3/port-security/

HTH.

Regards,

RS.

 

2 REPLIES
New Member

The following solved the

The following solved the issue.

 

Thanks in advance

 

sw1(config-if)#no switchport port-security mac-address st
sw1(config-if)#no switchport port-security mac-address sticky
sw1(config-if)#shut
sw1(config-if)#shutdown
sw1(config-if)#no sh
sw1(config-if)#no shutdown
03:23:47: %LINK-5-CHANGED: Interface FastEthernet0/9, changed state to administratively down
sw1(config-if)#no shutdown
sw1(config-if)#
03:23:56: %LINK-3-UPDOWN: Interface FastEthernet0/9, changed state to down
sw1(config-if)#
03:24:06: %LINK-3-UPDOWN: Interface FastEthernet0/10, changed state to up
03:24:08: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to up
sw1(config-if)#
sw1(config-if)#
03:24:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to down
03:24:27: %LINK-3-UPDOWN: Interface FastEthernet0/10, changed state to down
03:24:32: %LINK-3-UPDOWN: Interface FastEthernet0/9, changed state to up
03:24:33: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/9, changed state to up

Hey Jack,Adding a link for

Hey Jack,

Adding a link for port-security for references:

http://packetlife.net/blog/2010/may/3/port-security/

HTH.

Regards,

RS.

 

31
Views
0
Helpful
2
Replies