We're putting an analyzer on the network and need to span ports to make the analyzer as the destination. I need to span ports from three different switches to the switch where the device is located. Here's the config I plan to use for one of them.
Does this look ok? Anything I'm missing?
Thanks in advance.
#Create RSPAN vlan:
#Create RSPAN source interfaces:
monitor session 1 source g1/0/9, g1/0/12, g2/0/11 both
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.