Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Port status ...

Hello,

Scenario:

I have C2960X- 48 gigabit Ethernet ports.

At the other end are computers.

 

Problem - Question:

The computer is turned off (not on standby),

But status of port is up ...

GigabitEthernet1/0/10 is up, line protocol is up (connected)

 Encapsulation ARPA, loopback not set
  Keepalive set (10 sec)
  Full-duplex, 10Mb/s, media type is 10/100/1000BaseTX
  input flow-control is off, output flow-control is unsupported

Here is show run:

interface GigabitEthernet1/0/10
 description Gi1/0/10 Port - 10
 switchport access vlan 350
 switchport mode access
 switchport voice vlan 290
storm-control broadcast level pps 50
 storm-control action shutdown
 spanning-tree portfast

end

There is only one PC connected, and PC is off.

Why I have port up and Full-fuplex, 10Mb/s?

Thank you in advance for any help you can provide.

2 ACCEPTED SOLUTIONS

Accepted Solutions

this issue should be given to

this issue should be given to the manufacturer network card

Hall of Fame Super Gold

This behaviour is normal if

This behaviour is normal if your PC is TURNED OFF and not POWERED OFF.  

 

When you turn off the PC, the power is still enabled.  This NIC card is active due to Wake-on-LAN.  So the NIC listens out for the "magic packet".  

4 REPLIES

this issue should be given to

this issue should be given to the manufacturer network card

New Member

Thanks to both of you.Regards

Thanks to both of you.

Regards,

Hall of Fame Super Gold

Thank you for taking the time

Thank you for taking the time to rate our posts.  :)

Hall of Fame Super Gold

This behaviour is normal if

This behaviour is normal if your PC is TURNED OFF and not POWERED OFF.  

 

When you turn off the PC, the power is still enabled.  This NIC card is active due to Wake-on-LAN.  So the NIC listens out for the "magic packet".  

50
Views
0
Helpful
4
Replies