Port tracking for L2-L3 devices

[aalonzo93]

Hello,

I'm looking for the CLI command to enable Port tracking Feature on my 3750 switch device. Y found it for MDS SAN devices but nothing about switch or router.

The idea is to bring down an designated interface following the status of another one. this will help to ensure a physical propagation of an attached device's Interface.

Thanks fo all

Alain

[rais]

You may look at the following link:

http://www.cisco.com/en/US/docs/switches/lan/catalyst3750/software/release/12.2_25_see/configuration/guide/swethchl.html#wp1285305

Thanks.

[aalonzo93]

Hi rais,

thanks for your response,link-state tracking could be working as the switchport backup interface command line..

is it ?

regards

alain

[aalonzo93]

Hi rais,

thanks for your response,link-state tracking could be working as the switchport backup interface command line..

is it ?

regards

alain

[aalonzo93]

Hi rais,

thanks for your response,link-state tracking could be working as the switchport backup interface command line..

is it ?

regards

alain