Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Port Usage

Guys i have couple of 6509 running CAtOs....now i want to see ports status interms of last activity recorded on each port.....what i sthe command i tried show port usage....it tell me th elast date it went up or down (i believe so correct me if i m wrong)....i want to know when was the last data activity on each port....can someone please help me out? thanks

  • LAN Switching and Routing
2 REPLIES
New Member

Re: Port Usage

Hi, you can see the last time your ports had any activity in or out using show int modifiers, these commands reduce show output to smaller detail information. Try this command for data activity, hope it helps.

switchint#show int fa0/22 | inc output

Last input 00:00:18, output 00:00:00, output hang never

5 minute output rate 2000 bits/sec, 3 packets/sec

26896 packets output, 2337231 bytes, 0 underruns

0 output errors, 0 collisions, 4 interface resets

0 output buffer failures, 0 output buffers swapped out

switchint#show int fa0/22 | inc input

Last input 00:00:09, output 00:00:00, output hang never

Output queue 0/40, 0 drops; input queue 0/75, 0 drops

5 minute input rate 1000 bits/sec, 3 packets/sec

20117 packets input, 1865955 bytes

38 input errors, 37 CRC, 1 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

New Member

Re: Port Usage

Mate i rekon this command is for IOS i nhave said that i have CATOS it doesnt work on CATOS.......cheers

226
Views
0
Helpful
2
Replies