How is port VLAN membership assigned on a VTP client ? What commands should be used ? I know that VTP server switches store all the VLAN configuration so that management of this information is centralised. However, on such a VTP server switch how is the port VLAN membership assigned for a VTP client switch ? How would the VTP client switch be identified ?
On VTP clients you can't create VLANs, you must create the VLAN on the VTP server first, and the server will advertise this VLAN to the clients, and afterwards you can assign any port on the client to this VLAN via "switchport access vlan x".
Thank you for you reply, Mohammed. Does this mean that a VTP server does not store the assignment of ports to VLAN's for VTP client switches ? My understanding of VTP was that it was designed to save having to perform any VLAN configuration on the VTP client switches, including assigning their ports to VLAN's. This information must therefore be stored locally in NVRAM on a VTP client switch ?
Hi, Thanks for reply. This post has resolved my issue and I was going to mark it with a red check mark but cannot see any way to do this. It only offers options to rate it on a scale of 1-5. How can I mark it with the red check mark ?
If any reply has benefited you, you can give it a rate on a scale from 1(meaning not helpful) to 5 (extremely helpful), and finally for the reply that has solved your problem you can kindly check the "Resolved my issue" check box and then press submit.
Thank you for using the rating system, it makes the forum more helpful.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...