That command usually shows the portchannel you created (21 in your case) and not all the internal once.
It usually looks some thing like this:
xxxx-Switch(config-if)#do sh etherc s Flags: D - down P - bundled in port-channel I - stand-alone s - suspended H - Hot-standby (LACP only) R - Layer3 S - Layer2 U - in use f - failed to allocate aggregator
M - not in use, minimum links not met u - unsuitable for bundling w - waiting to be aggregated d - default port
Number of channel-groups in use: 1 Number of aggregators: 1
Group Port-channel Protocol Ports ------+-------------+-----------+----------------------------------------------- 10 Po10(SD) LACP Gi1/0/20(D) Gi1/0/21(D)
Usually that means your port channel configs do not match on each end . Something in your configs on either the cisco or hp do not match. If you are trunking across the channel all your trunking parameters must match. Also when you configure the channel , have them shutdown and then bring your ports up via the port channel SVI doing a no shut. You may have to delete the current ones and recreate them .
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...