Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

portfast?

On a 2960...what is the command to show if portfast is enable on the ports?

5 REPLIES

Re: portfast?

Community Member

Re: portfast?

thanks for reply but i know how to put a port on portfast...i just wanted to know if there was any sh commands to display ports in portfast. Rather than doing a sh run...

Re: portfast?

Hi,

Sorry about that, no its just the show run to verify.

Edit|

show spanning tree interface | in PortFast

Re: portfast?

Hi Lejoe,

I thought of that at first, but doing that will only show lines spanning-tree portfast and nothing more. It will not indicate which ports it is configured on.

Mark

Re: portfast?

Jeff,

You can use the "show spanning-tree interface faX/X detail" command. It will show portfast is enabled or disabled. I don't know of a command that will quickly display all the ports of a switch that are configured for portfast.

HTH,

Mark

152
Views
0
Helpful
5
Replies
CreatePlease to create content