We configured Remote SPAN in one 3560G switches as below:
monitor session 1 source vlan 22 rx
monitor session 1 destination remote vlan 34
monitor session 2 source remote vlan 34
monitor session 2 destination interface gi0/5
The remote vlan 34 carrys the traffic copied from the other switches connected to this 3560G. Gi 0/5 is the sniffer port connected to one PC. I can see the traffic from the other switch on the sniffer port. That means the remote span vlan does copy the traffic from the other switches. But the issue is the traffic in this 3560G switch doesn't get copied to remote vlan 34. The configuration we have is to copy the traffic in vlan 22 in this switch to remote vlan 34 and then copy the data in remote vlan 34 to the sniffer port.
But the configuration like this doesn't work for us. Is this a bug for SPAN or we do something wrong. Please advise. Thanks a lot.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...