Dear/Dearest Support Community
I have a Cisco Catalyst WS-6509 switch with the following problem:
Each time the switch reloads, it adds this in the config to all my POE interfaces:
interface FastEthernet9/1
no ip address
switchport
switchport access vlan xx
switchport mode access
power inline auto max 7000
end
After a reload I always have to perform a no power inline command, to remove the 7000 milli-watts limit.
Even tough I run the copy run start after this, each time it reloads, it shows up again.
Very annoying when you have POE devices connected which need more than 7000 milli-watts.
Any suggestions?
sh ver:
Cisco Internetwork Operating System Software
IOS (tm) c6sup2_rp Software (c6sup2_rp-PK9S-M), Version 12.2(18)SXD6, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2005 by cisco Systems, Inc.
Compiled Wed 17-Aug-05 18:56 by evmiller
Image text-base: 0x4002100C, data-base: 0x422F0000
ROM: System Bootstrap, Version 12.1(11r)E1, RELEASE SOFTWARE (fc1)
BOOTLDR: c6sup2_rp Software (c6sup2_rp-PK9S-M), Version 12.2(18)SXD6, RELEASE SOFTWARE (fc1)
HSsec-CORE-S01 uptime is 3 hours, 25 minutes
Time since HSsec-CORE-S01 switched to active is 3 hours, 24 minutes
System returned to ROM by power-on (SP by power-on)
System restarted at 07:12:50 BRUSSELS Fri Oct 10 2014
System image file is "sup-bootflash:/c6k222-pk9s-mz.122-18.SXD6.bin"
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
cisco WS-C6509 (R7000) processor (revision 2.0) with 458752K/65536K bytes of memory.
Processor board ID SCA05020CTK
R7000 CPU at 300Mhz, Implementation 0x27, Rev 3.3, 256KB L2, 1024KB L3 Cache
Last reset from power-on
X.25 software, Version 3.0.0.
Bridging software.
9 Virtual Ethernet/IEEE 802.3 interface(s)
48 FastEthernet/IEEE 802.3 interface(s)
252 Gigabit Ethernet/IEEE 802.3 interface(s)
381K bytes of non-volatile configuration memory.
32768K bytes of Flash internal SIMM (Sector size 512K).
Configuration register is 0x2102
