Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Power redundancy mode

I'm not able to find power redundancy mode when i do show power on my Cisco 4510R+R with SUP7E.

switch#show power
Power                                             Fan      Inline
Supply  Model No          Type       Status       Sensor   Status
------  ----------------  ---------  -----------  -------  -------
PS1     PWR-C45-6000ACV   AC 6000W   good         good     good  
PS1-1                         220V   good        
PS1-2                         220V   good        
PS2     PWR-C45-6000ACV   AC 6000W   good         good     good  
PS2-1                         220V   good        
PS2-2                         220V   good        

Power supplies needed by system    : 2
Power supplies currently available : 2

Power Summary                      Maximum
(in Watts)              Used     Available
----------------------   ----     ---------
System Power (12V)       1295        4000
Inline Power (-50V)       140        8700
Backplane Power (3.3V)     40          40
----------------------   ----     ---------
Total                    1475 (not to exceed Total Maximum Available = 10900)

                             Output Power To Chassis            Input Power
                    =======================================  ==================
Power Measurement   System Power (12V)  Inline Power (-50V)
(in Watts)                (+/- 12W)        (+/- 50W)              (+/- 5%)
------------------  ------------------  -------------------  ------------------
PS1                        288                   50                   61
PS2                        288                   50                   61
------------------  ------------------  -------------------  ------------------
Total                      576                  100                  122

Note: System power budget is 1295 Watts to accommodate peak power utilization.

When i do show power on my Cisco 65000 the first line shows the power redundancy mode,  I have all other show power related command but couldn't find redundancy mode, please advise.

thanks

1 REPLY

Power redundancy mode

The power supplies needed by system: 2 indicates that the switch is in combined mode.

switch#show power
Power                                             Fan      Inline
Supply  Model No          Type       Status       Sensor   Status
------  ----------------  ---------  -----------  -------  -------
PS1     PWR-C45-6000ACV   AC 6000W   good         good     good  
PS1-1                         220V   good        
PS1-2                         220V   good        
PS2     PWR-C45-6000ACV   AC 6000W   good         good     good  
PS2-1                         220V   good        
PS2-2                         220V   good        

Power supplies needed by system    : 2
Power supplies currently available : 2

which clarify if your requirment is two and you have two then can not run in redudant mode.

Thanks

Ajay

461
Views
0
Helpful
1
Replies
CreatePlease to create content