Hi, the PS2-1300Watt AC of my Cat6500 (the old chassis version hardware ver3.0, it is not the E) is out. We buy another one, but this one has 4000Watt.
The CatOS version is 6.3(3). And supervisors 2.
We are running over non-redundant power configuration.
We replace the PS2, but show sys command shows:
PS1 Capacity: 1153.32 Watt
PS2 Capacity: 0 Watt
But, the show ver shows:
PS1 Module: WS-CAC-1300W
PS2 Module: WS-CAC-3000W
We dont understand if we have a problem with the chassis, the CatOS version, and what will happend if we remove the PS1, and if we switch to redundant... because the redundant configuration could shutdown the PS1 to switch to the PS2 because it has higher power wattage...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.