We have a 6500 switch that currently has two 3000w PS and we would like to upgrade both to 6000w. Has anyone done this before and was there any impact. If we replace the first 3000w first and replace it with 6000w PS, will this cause any problems since one is running 3000w and the other is 6000w? Another concern is if assuming different watts of PS works, will it failover to 6000w once the last 3000w PS is pulled out? Any reply is highly appreciated. Thanks.
Hello. When we upgraded our power supplies on 6506, we didn't have any problems. Just wait until the new PS becomes operational (all LEDs ok, syslog says that everything is ok, and check "show environment power" command output), and then replace the second one.
But don't delay, as system does something depending on your set up.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.