Hi all, On my dialer config I put a ppp chap hostname and password for the remote router, I then did a debug ppp negotation, it said no username found, so I set up a username under the global config and it worked, why is this, I thought that the ppp hostname should work ?
When we configure the dialer config, router always look for the username and password configured on the router local database.It doesnot look for the Username password under the dialer interface. Please look at link below for config :
By default Cisco router identifies it self with its hostname.If you want override that hostname when the router negotiates with the peer router then we use that command " ppp chap hostname " under the interface. Plesae see the link below for more information
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...