I have a necessity to create PVLAN's in the 1025-4094 range on 6500.
CCO notes the following ...
"You can configure private VLAN parameters and RSPAN for extended-range VLANs; however, all other parameters for extended-range VLANs use the system defaults only."
Any idea what the system defaults actually are - cant seem to find additional detail.
I am trying to figure out if there are any issues I could run into by going down this route (apart from having to enable mac address reduction for which needs its own precautions. If anyone has done this in their environment successfuly or has any learnings maybe you can post.
Extended VLANS only support Ethernet, and are not prpogated via VTP.
Also from my BCMSN study guide "As a best practice, assign extended VLANs beginning with 4094 and work downward because some switches use extended-range VIDs for internal use, starting at the low end of the extended range"
use the command "show vlan internal usage" to check.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...