I want to configure 2 private vlans between my firewall-core-access switch.
The setup is:
firewall - trunk to coreSW - trunk to accessSW
The firewall is the L3 device for 2 new VLANs.
On the trunk between the FW and the core are multiple VLANs configured.
Access switch is C3560-E.
On the side of the Firewall - core, I only want to see my 2 primary VLANs (10,20). From my core, I want a trunk to my access switch carrying those 2 primary VLANs, and then split them up into secondary VLANs.
I checked the docs and I think if I want to do this, I need 2 physical connections from my core to my access switch because I can only configure promiscuous mode for a single VLAN.
After looking at CCO, I found that on a C4500 one can configure
switchport mode private-vlan trunk promiscuous
I think this command would sovle my problem, however, it is not (yet) implemented in the IOS on my C3560-E.
Does someone know when this will be the case, and if it indeed would solve my problem. If you would know any other solutions, I would be glad to hear them!
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.