I have an access device which for some reason requires each connection to have its own vlan. Behind this I have a Cisco Catalyst 3750G switch. I need to set up the switch so that multiple vlans on this access device can use the same subnet. I believe the way to do this is using private vlans, but as I have never used private vlans, I am not sure if I am doing this right.
Here's the config I've got so far:
private-vlan association 501
private-vlan association 502
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 55,501,502
switchport mode trunk
vlan 55 works through the access device, but vlan 501 does not. All of the documentation for private vlans involves them assigned to individual access ports. Is there any reason this should not work?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.