Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

privilege for show commands

Hi all, is there a priv level I can give to my users to only allow them to do certain show commands ?

4 REPLIES

Re: privilege for show commands

You need to "move" the show commands to another privilege level then assign the user to that level.

New Member

Re: privilege for show commands

For example:

Router(config)#privilege exec level 4 sh run

Router(config)#username cisco privilege 4 password cisco

New Member

Re: privilege for show commands

what is the enable level for then? can I not use this ?

Bronze

Re: privilege for show commands

Enable level is level 15.

You can create a new user with a level lower than that.

Then you will need to associate the show commands to the appropriate level.

Keep in mind that the sh run output might not show everything, because each command shown in the config would need to be authorized for the restricted user to see it.

159
Views
0
Helpful
4
Replies
CreatePlease login to create content