Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Privilege level: Trying to setup a user so that he can only change interfaces configuration

I'd like to setup a user so that he can only edit the switches' interfaces (i.e. change vlan access, etc...) but nothing else. I added the commands below to no avail.

username help_desk privilege 7 password 7 0832584F1B0D54
privilege configure level 7 interface
privilege exec level 7 show
privilege exec level 7 configure terminal
privilege exec level 7 interface

Any ideas how i can get this done?

Regards,

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Privilege level: Trying to setup a user so that he can only

I'm afraid this is not possible, please refer to this technote for additional explanation:

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml

In short, if you need to get into config mode, you need priv 15.

Regards,

Edison

2 REPLIES
Hall of Fame Super Bronze

Re: Privilege level: Trying to setup a user so that he can only

I'm afraid this is not possible, please refer to this technote for additional explanation:

http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a00800949d5.shtml

In short, if you need to get into config mode, you need priv 15.

Regards,

Edison

Bronze

Re: Privilege level: Trying to setup a user so that he can only

I was afraid that will be the only options after reading few postings but I wanted to give it a stab in this forum as well.

Thanks,

325
Views
0
Helpful
2
Replies
CreatePlease to create content