I have not had much luck searching appropriately, and I'm hoping someone may have a configuration they can share.
I have Catalyst switches and 2811 routers that I need to give the client IT Director access to. I want to give them their own credentials (i.e. username itadmin priv 14 pass 0 password) - I basically want to allow them access to everything except the ability to change login methods and credentials.
I don't want them to see/edit line commands or username settings.
Any quick setup configs would be appreciated. I have not done one of these yet and I'm being directed to turn this around quickly.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...