Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Community Member

PRIVILIGE COMMNAD

hi all,

i applied following command

"privilege interface level 6 vlan-range"

but not able to c any sub-commands when i reach...

conf t--interface gig x/y--vlan-range--

only "no" is there.

Any clues

7 REPLIES
Community Member

Re: PRIVILIGE COMMNAD

Is any available to answer this qs????

Highlighted

Re: PRIVILIGE COMMNAD

What kind of device is are you working on?

Community Member

Re: PRIVILIGE COMMNAD

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA, RELEASE SOFTWARE (fc1)

Re: PRIVILIGE COMMNAD

you might need "all" option to enable all sub-commands when using privilege command.

Community Member

Re: PRIVILIGE COMMNAD

in

"privilege interface level 6 vlan-range"

all keyword is not acceptable at all in any privilige mode exec/configure/interface

Re: PRIVILIGE COMMNAD

Yeah, this feature might not be in there.

Is there "priviledge vlan-range"? If not, you have to use AAA to control this.

Community Member

Re: PRIVILIGE COMMNAD

no, but under interface level 15, i can access vlan-range then service-policy, but problem is all commands will be enabled even if i will restrict thru privilige.

Also checked CLI role based views,, but i dun know y my 4501 ios doesnt support that one too i have ip voice services

134
Views
0
Helpful
7
Replies
CreatePlease to create content