Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PRIVILIGE COMMNAD

hi all,

i applied following command

"privilege interface level 6 vlan-range"

but not able to c any sub-commands when i reach...

conf t--interface gig x/y--vlan-range--

only "no" is there.

Any clues

7 REPLIES
New Member

Re: PRIVILIGE COMMNAD

Is any available to answer this qs????

Re: PRIVILIGE COMMNAD

What kind of device is are you working on?

New Member

Re: PRIVILIGE COMMNAD

Cisco IOS Software, Catalyst 4000 L3 Switch Software (cat4000-I5S-M), Version 12.2(25)EWA, RELEASE SOFTWARE (fc1)

Re: PRIVILIGE COMMNAD

you might need "all" option to enable all sub-commands when using privilege command.

New Member

Re: PRIVILIGE COMMNAD

in

"privilege interface level 6 vlan-range"

all keyword is not acceptable at all in any privilige mode exec/configure/interface

Highlighted

Re: PRIVILIGE COMMNAD

Yeah, this feature might not be in there.

Is there "priviledge vlan-range"? If not, you have to use AAA to control this.

New Member

Re: PRIVILIGE COMMNAD

no, but under interface level 15, i can access vlan-range then service-policy, but problem is all commands will be enabled even if i will restrict thru privilige.

Also checked CLI role based views,, but i dun know y my 4501 ios doesnt support that one too i have ip voice services

124
Views
0
Helpful
7
Replies
CreatePlease login to create content