Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem active to balance between two equipment

Model: CISCO WS-C6509 Description of the problem: We have trunk qualified between the equipment cpdv_01 and cpdv_02. Trunk has a connection main in the FastEthernet8/19 interface and secondary in the FastEthernet9/38. The problem is that they are balancing the traffic, and leaves a similar amount in both interfaces. We opened this consultation to them so that they confirm to us if this is normal and that to make to avoid it.

cpdv_01#sho run int gi8/19

Building configuration...

Current configuration : 297 bytes

!

interface GigabitEthernet8/19

description trunk2a_telefonicasa02

no ip address

speed 1000

duplex full

no snmp trap link-status

switchport

switchport trunk allowed vlan

1,2,5-7,12,13,15,20-28,33

1 REPLY
Cisco Employee

Re: Problem active to balance between two equipment

Please explain your problem in details.. its very hard to understand the problem that you are facing with the above explanation..

-amit singh

89
Views
0
Helpful
1
Replies