Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem after command "switch supervisor" on Catalyst 6000

after a switch of supervisor I can't reach some server connected the Catalyst 6000. When I set "show ip arp on the msfc" I see the IP-address and the mac-address but I can't ping the machine

The catOs version ist 7.6(10)

cat6009> (enable) sh module

Mod Slot Ports Module-Type Model Sub Status

--- ---- ----- ------------------------- ------------------- --- --------

1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok

15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok

2 2 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes standby

16 2 1 Multilayer Switch Feature WS-F6K-MSFC no ok

3 3 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

4 4 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

5 5 16 1000BaseX Ethernet WS-X6516-GBIC no ok

6 6 48 10/100BaseTX Ethernet WS-X6348-RJ-45 no ok

7 7 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX no ok

8 8 48 10/100BaseTX Ethernet WS-X6248-RJ-45 no ok

9 9 48 10/100/1000BaseT Ethernet WS-X6148-GE-TX no ok

Please Help

4 REPLIES
Purple

Re: Problem after command "switch supervisor" on Catalyst 6000

Did you try clearing the cam table and the arp table on the msfc ?

New Member

Re: Problem after command "switch supervisor" on Catalyst 6000

Hi,

I have tried out to clear the arp table on the mscf but doesn't help. There are about

6 server are affected.

Thanks

Silver

Re: Problem after command "switch supervisor" on Catalyst 6000

Are they in the same VLAN?

New Member

Re: Problem after command "switch supervisor" on Catalyst 6000

no, they are in different VLAN

340
Views
0
Helpful
4
Replies