Problem in Network switches 2950 series, which was connected to SRW 2024 Gigabit switches, a problem was in 2920 10/100 switches , a uplink port's power off, when switch was restarted then, uplink port working normally, but suddenly after half / an hour, uplink port down again, so please help, and what is best solution of network switches configuration. because switches was not configured or managed, just simply switches was connected through Crosse cable one by one,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...