Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

problem daughter card catalyst 4507R

I have a problem with a Catalyst 4507R with Supervisor IV, IOS 12.1 (19) EW and daughter card Netflow WS-F4531

Is it possible to see the flow of a VLAN or between VLANS?

If possible, what version of IOS is needed. Currently only identifies traffic flows on multicast or broadcast

Netflow configuration is this

ip cef
ip flow-export destination 10.11.12.13 2055
ip flow-export version 5
ip flow-cache timeout active 1
ip route-cache flow infer-fields  o ip route-cache flow

1 REPLY
Hall of Fame Super Silver

Re: problem daughter card catalyst 4507R

Hello JCastanos,

if you mean that you would like to see netfflow to collect stats about bridged traffic see

HW requirements:

To use the NetFlow feature, you must have the Supervisor Engine V-10GE (the functionality is embedded in the supervisor engine), or the NetFlow Services Card (WS-F4531) and either a Supervisor Engine IV or a Supervisor Engine V.>>> you are fine with sup IV and WS-F4531

you need to add ip flow ingress on layer3 interfaces

Switch(config)# ip flow ingress  layer2-switched

>> To enable switched IP flow collection on all interfaces, you need to enter both the ip flow ingress and
ip flow ingress layer2-switched commands.

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/44sg/configuration/guide/nfswitch.html#wp1040881

You could think of upgrading to 12.2(44)SE or later because your release is rather old but HW is fine.

Hope to help

Giuseppe

396
Views
0
Helpful
1
Replies
CreatePlease to create content