Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem in show ip route?

Is someone who can help me? What is the meaning of the result "%Network not in table"?

Router>show int serial1

Serial1 is up, line protocol is down

Hardware is MK5025

Description: ****Example****

Internet address is 192.168.1.1/30

MTU 1500 bytes, BW 512 Kbit, DLY 20000 usec, rely 131/255, load 1/255

Encapsulation PPP, loopback not set, keepalive set (10 sec)

LCP Listen

Closed: IPCP, CDPCP

Last input 00:07:58, output 00:00:14, output hang never

Last clearing of "show interface" counters 12:50:32

Input queue: 0/75/0 (size/max/drops); Total output drops: 0

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops)

Conversations 0/75/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

5 minute input rate 0 bits/sec, 0 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

92 packets input, 7719 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

29464045 input errors, 29253742 CRC, 0 frame, 210307 overrun, 0 ignored, 0 abort

9611 packets output, 134554 bytes, 0 underruns

0 output errors, 0 collisions, 2415 interface resets

0 output buffer failures, 0 output buffers swapped out

2451 carrier transitions

Router>show ip route 192.168.1.1

% Network not in table

Router>

3 REPLIES
bjw Silver
Silver

Re: Problem in show ip route?

The Serial interface is not up/up, it sees a physical connection but no protocol.

The connected 192.168.1.1 address will only be in the routing table if interface and line protocol are both up.. This is a PPP encapsulated interface and it appears possible the other end of the PPP link isn't uup or configured properly.

New Member

Re: Problem in show ip route?

Now I understand. Thanks for the answer. :)

May I know what are the other factor of going down of the line protocol (Line protocol is down)? Can you give me an other scenarios or examples?

Thanks in advance..

Martee Sacramento

bjw Silver
Silver

Re: Problem in show ip route?

There are many scenarios. I use a mostly HDLC encapsulated serial interfaces on leased T-1 circuits, a reason line protocol could be down might include the telco provider having some of its switch gear down or not working right.

Here's the Cisco direction for PPP interfaces.

http://www.cisco.com/en/US/tech/tk482/tk607/technologies_white_paper09186a0080094699.shtml

219
Views
0
Helpful
3
Replies