I have a problem in my topology, one at a time about if there is no traffic on the vlan, router R2 fails to ping the ip of the remote end svi, issu cause disorders seen everything so normalizes after I ping from (Vlan10)-R1 to ip in svi R2 - (Vlan10). when the problem another vlan trunk occurs at the same link with the switching hub continues normally. the arp table set out their macs and addresses. In troubleshooting at layer 2 and not detected any problems. Someone already I witness such a problem?
I am using switch module in any senario model HWIC-4ESW.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...