Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PROBLEM MPLS VPNV4

Hello,

I have configured two non connected route reflector directly, but with connectivity.

I use OSPF like internal routing. And BGP for MPLS.

When I believe a vrf, it only leaves me for a RR, and if I throw RR I am fallen the vrf. I want that it leaves for two RR, to have redundacia for if a RR falls.

That I should add?

thank you

2 REPLIES
Silver

Re: PROBLEM MPLS VPNV4

Hi,

Sorry your explanation is not very clear, can you perhaps give us a diagram of the setup?

If you are asking how to have redundancy for PE's when one of two Route Refecfectors fail, then all you need to do have a BGP VPNV4 session to each RR from each PE.

If you give us more info, we can help you out!

Cheers,

LR

New Member

Re: PROBLEM MPLS VPNV4

Sorry. You are right. I explain to myself well.

I have three ring as of the topology which attach you, and each one of the rings this connected to two 6500.

When I believe a vrf between two 2800 of two different rings, according to the configuration that I attach you, two RR should plunder, but only scamp one. I am almost sure that it is problem of BGP, but I am not sure.

I also attach you the config of the two 6500 of the ring.

thank you

108
Views
0
Helpful
2
Replies