I've a problem when upgrade IOS advipservices 12.2(25)-SED to advipservices 12.2(25)-SEE2 on Cisco Catalyst 3750G-24-TS switch , The upgrade process was done well , but when I was reloaded the switch ,the log is complain this messages all the time.
"%SCHED-2-MESSAGE: Key (Cluster Base) does not match key (OSPF Hello) of process (177) in process_send_message request Process= "CDP Protocol", ipl= 0, pid= 89 Traceback= B52F6C 100B6A4 A47258 A4847C A4282C A41EA8 90CA44 90300C".
I don't have any clue about this message. But it seem that the switch is work properly. So Could someone please help me?
%SCHED-2-MESSAGE : Key ([chars]) does not match key ([chars]) of process ([dec]) in process_send_message request
Explanation An attempt has been made to send a message to a process. The key associated with the process did not match the key in the message. This condition occurs when an incorrect process id is used in the send message request.
Recommended Action Copy the error message exactly as it appears on the console or in the system log, contact your Cisco technical support representative, and provide the representative with the gathered information.
When do you plan to stack them? If you want to stack them, then you should have the same IOS on both.
Otherwise you could wait for the new version scheduled for December, and then stack them once the new version is out. It's up to you, but usually using an older release in production is better because it's been tested more widely.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.