I'm new to using Cisco router. On the network I have to configure they are using an Cisco 851 router. I'm installing a new server which requires port 443 to be open. Port 80 is already open because of an old server which we will no longer need. I tried adding the port 443 but to no avail.
Below the configuration file.
Could anyone point out to me what is wrong and what I am doing wrong in opening port 443: ( I deleted/changed from below the crypto pki certificate, admin privilege 15 secret 5 and some ip adress pointing out to our location, because I had an feeling that I do not want those on the internet)
Current configuration : 14177 bytes
no service pad
service timestamps debug datetime msec localtime show-timezone
service timestamps log datetime msec localtime show-timezone
logging buffered 51200
logging console critical
enable secret 5 $
no aaa new-model
clock timezone Berlin 1
clock summer-time Berlin date Mar 30 2003 2:00 Oct 26 2003 3:00
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...