Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Problem to display logging

Hello to all,

if i perform a "show logging" i can get this:

cme#show log

Syslog logging: enabled (11 messages dropped, 3 messages rate-limited,

                0 flushes, 0 overruns, xml disabled, filtering disabled)

No Active Message Discriminator.

No Inactive Message Discriminator.

    Console logging: level debugging, 23510 messages logged, xml disabled,

                     filtering disabled

    Monitor logging: level debugging, 5081 messages logged, xml disabled,

                     filtering disabled

        Logging to: vty514(208)

    Buffer logging:  level debugging, 19 messages logged, xml disabled,

                     filtering disabled

    Logging Exception size (4096 bytes)

    Count and timestamp logging messages: disabled

No active filter modules.

    Trap logging: level notifications, 11649 message lines logged

        Logging to 10.0.0.204  (udp port 514,  audit disabled,

              authentication disabled, encryption disabled, link up),

              11649 message lines logged,

              0 message lines rate-limited,

              0 message lines dropped-by-MD,

              xml disabled, sequence number disabled

              filtering disabled

Log Buffer (4096 bytes):

i need to see the 5081 messages that are logged in "Monitor logging" what is the correct way in order to display this messages?

thanks and regards.

1 REPLY

Re: Problem to display logging

Hi,

IMHO, issuing "term monitor" will start displaying the messages on your terminal screen on-line.

But no way to display a message history.

See logging monitor at  http://www.cisco.com/en/US/docs/ios/netmgmt/command/reference/nm_09.html#wp1066253

and terminal monitor at http://www.cisco.com/en/US/docs/ios/12_2/configfun/command/reference/frf003.html#wp1019329

HTH,

Milan

220
Views
0
Helpful
1
Replies