Hello to all,
if i perform a "show logging" i can get this:
cme#show log
Syslog logging: enabled (11 messages dropped, 3 messages rate-limited,
0 flushes, 0 overruns, xml disabled, filtering disabled)
No Active Message Discriminator.
No Inactive Message Discriminator.
Console logging: level debugging, 23510 messages logged, xml disabled,
filtering disabled
Monitor logging: level debugging, 5081 messages logged, xml disabled,
filtering disabled
Logging to: vty514(208)
Buffer logging: level debugging, 19 messages logged, xml disabled,
filtering disabled
Logging Exception size (4096 bytes)
Count and timestamp logging messages: disabled
No active filter modules.
Trap logging: level notifications, 11649 message lines logged
Logging to 10.0.0.204 (udp port 514, audit disabled,
authentication disabled, encryption disabled, link up),
11649 message lines logged,
0 message lines rate-limited,
0 message lines dropped-by-MD,
xml disabled, sequence number disabled
filtering disabled
Log Buffer (4096 bytes):
i need to see the 5081 messages that are logged in "Monitor logging" what is the correct way in order to display this messages?
thanks and regards.
