Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Problem while stacking the Cisco 2960 switch

Hi All,

I am having issue while doing the stacking on the switch. Detail is as followed:-

We have two cisco 2960 switches in stack which are having a common IP. I want to add one more switch in the stack. So I make the same iOS of the new switch as with previous one and attached the stack cables. After that when I started all the switches than switch 1 & switch 2 showing duplicate IP error. and stacking also not done.Although all the switch 3 ports appear in the Master configuration files.

Could you please help me on this issue.

Thanks & Regards,

Gaurav

  • LAN Switching and Routing
5 REPLIES
New Member

Problem while stacking the Cisco 2960 switch

share the configs and logs please

New Member

Re: Problem while stacking the Cisco 2960 switch

Hi Parvesh,

Please find the configuration file when there was two swtich in stack. Right now due to duplicate IP issue I shutdown 1 switch. So at present only 1 switch is working and other two switch are shutdown.

Thanks

Gaurav

New Member

Problem while stacking the Cisco 2960 switch

are you using flexstack ?

New Member

Problem while stacking the Cisco 2960 switch

Please check and confirm if you have connected the switches like this.

waiting for your revert.

New Member

Re: Problem while stacking the Cisco 2960 switch

I have done the same configuration. Problem is the first two switches was running on a single IP and when I added the third one then rest 2 switches are showing duuplicate IP address. And in all 3 switch Master LED is ON. Means that all the switch becomes master. How to overcome this.

Thanks

Gaurav

179
Views
0
Helpful
5
Replies