You will not see counters on this interface unless traffic is sent TO the IP address of interface vlan 2222 or if traffic is sent FROM the IP address of interface vlan 2222. Traffic that passes through vlan 2222 without hitting the layer 3 address should not generate counters. Try a test, ping the ip of that interface and then check it.
I am not sure because I am unaware of your topology and configs, but it could be that the destination host MAC address is already known by the source host thereby not needing to forward traffic to the default gateway. Just a thought, hope it helps.
If the switch has already build CEF table and switching the data in hardware, then you may not see any increase in the interface counters as all the packets are handled in hardware. You could use the command "show interface stats" to see the traffic through the specific interface. You can also use "show interface accounting" to see type of packets that are punted to the CPU.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.