Heres the story, I was upgrading the newest software images on a c2950G switch. So i follwed the step by step procedures from http://www.cisco.com/en/US/products/hw/switches/ps628/products_configuration_example09186a0080169627.shtml . I removed the current flash that was on the switch and then for some reason typed reload. This started the switch up without the IOS. Make a long story short I am now stuck in switch: prompt mode and I am unable to use xmodem to tranfer the newest IOS onto the switch. I am currently getting "no response remote system". I am using HyperTerminal. Any suggestion or ideas would be helpful. thank you
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...