Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Problem with Expert Setup on Catalyst 500

I am running Expert Setup on a Catalyst 500 and it runs through fine but when I run a browser it does not bring up the page.

I have gone through all the troubleshooting points without success.

What is the default Ip address of the box when it is set for expert setup?

Does it hand out dhcp addresses, becuase the laptop I am using is not getting a valid address it is getting a 169 addrees.

Can I just point my broswer to the ip address of the switch to run device manager?

1 REPLY
Silver

Re: Problem with Expert Setup on Catalyst 500

The default IP address, for Cisco IOS Software FY series releases is 10.0.0.1.

For Cisco IOS Software SEG series releases, the IP address is 169.254.0.1.

Refer to Initial Switch Configuration section.

http://www.cisco.com/en/US/partner/products/ps6545/products_tech_note09186a0080707fb0.shtml#topic4

100
Views
0
Helpful
1
Replies
CreatePlease to create content