Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Problem with Hot-Swapping - 4506-E

Hello,

I have a problem with the replacement of a switching module 4148 towards a switching module 4248-RJ45V…  Once the replacement carried out, the configuration of the module is erased…  If I replace a module of the same type (for example two 4248), there is no problem…

The switch is a 4506-E with a Supervisor IV.

IOS : cat4500-entservicesk9-mz.122-54.SG.bin

Anybody has already seen this ?

Hope this helps.

Regards,

AB

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Problem with Hot-Swapping - 4506-E

Hi AB,

This is expected behavior. Cisco modular switches erase the configuration when a different module is inserted than the previously installed module and keep the configuration if its the same type of module or no new module is inserted.

You can use the "module clear-config" command to remove the configuration if a module is removed.

Please take a look at this following link:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#after

JayaKrishna

3 REPLIES
Cisco Employee

Re: Problem with Hot-Swapping - 4506-E

Hi AB,

This is expected behavior. Cisco modular switches erase the configuration when a different module is inserted than the previously installed module and keep the configuration if its the same type of module or no new module is inserted.

You can use the "module clear-config" command to remove the configuration if a module is removed.

Please take a look at this following link:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#after

JayaKrishna

Community Member

Re: Problem with Hot-Swapping - 4506-E

Thx !

Community Member

Problem with Hot-Swapping - 4506-E

The "module clear-config" is only available in 6500, not on 4500 as far as I know:

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_configuration_example09186a008086ed2e.shtml#after

289
Views
5
Helpful
3
Replies
CreatePlease to create content