From this topology, I believe you have interface vlan 2 either on 2960 or 3750 (VTP server), so can you ping the 192.168.6.2 from that switch alternatively i want you to check the connectivity between DHCP server and relay agent.
I can Ping from the DHCP server all the way across to a PC on the 2960 being used for the P1 LAN. The PC also works fine on the domain, when configured with a static address. It too can ping across to the DHCP server.
The only problem at this point is obtaining a DHCP lease.
I could not find instructions on how to test DHCP connectivity.
Also, we do not have a DHCP relay. I thought that the IP-HELPER setting would take care of this.
If 3750 is already DHCP server for vlan 3 so i think creating a test scope for vlan 2 will help narrowing the issue. Try making the switch as DHCP server for vlan 2 as well and check if machine gets an IP address.
I am remote and the onsite IT spun up the DHCP server. When I checked it, they had left the Allow Filter Policy enabled for the scope with no MAC addresses in the list. This was preventing everything from getting an IP.
DHCP is working now. The switch config was correct after all.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.