Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

Problem with protocol donw On witch 2960G

Dear All Expert,

Could you let me know command as below that have issue ...this cisco switch 2960G(8ports)

FastEthernet0/7 unassigned YES unset up down

-The status is up but Protocol is down ,

i tried to no shut interface and tried to change cable but it still down ,

Could you let me know, why it happen ?

Best Regards,

Rechard_hk

2 REPLIES
Purple

Re: Problem with protocol donw On witch 2960G

Post a "show interface status . What is hooked to port 7 ?

New Member

Re: Problem with protocol donw On witch 2960G

dear Glen,

Sorry now i so far from Cisco switch but i was show int br only:

Branch-Switch#sh ip int br

Interface IP-Address OK? Method Status Protocol

Vlan1 unassigned YES NVRAM administratively down down

Vlan16 192.168.16.253 YES NVRAM up up

FastEthernet0/1 unassigned YES unset up up

FastEthernet0/2 unassigned YES unset up up

FastEthernet0/3 unassigned YES unset up up

FastEthernet0/4 unassigned YES unset up up

FastEthernet0/5 unassigned YES unset up up

FastEthernet0/6 unassigned YES unset down down

FastEthernet0/7 unassigned YES unset up down

FastEthernet0/8 unassigned YES unset up up

GigabitEthernet0/1 unassigned YES unset up up

I did not show int status...

Best Regards,

Rechard_hk

114
Views
0
Helpful
2
Replies
CreatePlease to create content