Problem with router Cisco 1700 and HP J4900A ProCurve Switch 2626
Hi, first of all, sorry for my inglish :)
I have two router Cisco 1700 with HSRP and load balancing enabled, and 3 HP J4900A ProCurve 2626 switches, each router Cisco is pluged to a diferent swicth.
Problem is that sometimes it starts lossing packets. When i do pings to the lan ip of booth routers i also losse packets, even if i am doing ping in the same network where the routers are. The only way to get things work again is rebooting the switches.
any ideas of whats going on? or possible things to check?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...