Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Problem with routing at old 2600

Hi ppl,

I have nooby problem with my old 2600 router.

I have network as shown at attached picture - My PC (with IP 192.168.0.2/24 and Def GW 192.169.0.1), Cisco 2600 with 2 Ethernet ports (in - E0/1 with IP 192.168.0.1, out - E0/0 with IP 10.244.16.198) and Internet Gateway Server (with in IP 10.244.16.1/24 and out IP 80.xxx.yyy.zzz).

Cisco configuration is:

___START___

version 12.2

service timestamps debug uptime

service timestamps log uptime

no service password-encryption

!

hostname Router

!

enable secret 5 XXXXXXXXXXXXXXX

!

ip subnet-zero

!

!

!

interface Ethernet0/0

ip address 10.244.16.198 255.255.255.0

half-duplex

!

interface Serial0/0

no ip address

shutdown

!

interface Ethernet0/1

ip address 192.168.0.1 255.255.255.0

half-duplex

!

interface Serial0/1

no ip address

shutdown

!

!

ip default-gateway 10.244.16.198

ip classless

ip route 0.0.0.0 0.0.0.0 10.244.16.1 permanent

no ip http server

ip pim bidir-enable

!

!

line con 0

line aux 0

line vty 0 4

password XXXXXXXXXXX

login

!

no scheduler allocate

end

___END___

So, from My PC I can ping 192.168.0.1 and 10.244.16.198, but nothing else (even 10.244.16.1). From router I can ping everithyng (even this forum :) ).

Could you please take a look and tell me where is an error?

Thanks in advance!

2 REPLIES
Hall of Fame Super Blue

Re: Problem with routing at old 2600

George

You need to NAT your internal 192.168.0.x addresses because they are not routable on the Internet so you won't get any response.

Add this to your config -

int e0/1

ip nat inside

int e0/0

ip nat outside

access-list 101 permit ip 192.168.0.0 0.0.0.255 any

ip nat inside source list 101 interface e0/0 overload

Jon

New Member

Re: Problem with routing at old 2600

I is mirracle! Just copy-paste - and everything started working!

THANKS!!!

110
Views
5
Helpful
2
Replies
CreatePlease to create content